5mm LED Red Color

5mm LED Red Color

SKU: SPKCOM005  · Category: Components › Light Emitting Diodes

RWF 100

In stock

Description

A classic 5 mm red LED (light-emitting diode): bright, low-power and long-lasting. It is the first component almost everyone uses in electronics β€” the β€œHello World” of hardware β€” and it remains the simplest way to show status, alarms and signals in any project.

It needs only a small current and a series resistor to work from an Arduino, ESP8266 or ESP32 pin. Pair it with our 220Ξ© resistors.

Features

  • Bright red light
  • Standard 5 mm round package
  • Low power β€” about 20mA
  • Long life
  • Breadboard friendly

Specifications

  • Color: red (about 620 – 630nm)
  • Forward voltage: 1.8 – 2.2V
  • Forward current: 20mA typical (30mA max)
  • Lens: 5 mm round
  • Viewing angle: about 30Β°

LED Polarity

  • Long leg = anode (+), connects towards the positive supply or Arduino pin.
  • Short leg = cathode (βˆ’), connects to GND. The rim of the LED also has a flat edge on this side.


Getting started

  1. Always use a resistor: Arduino pin β†’ 220Ξ© β†’ LED long leg; LED short leg β†’ GND.
  2. To calculate the resistor: (supply voltage βˆ’ 2V) Γ· 0.015A. For 5 V that gives 200Ξ© β€” so 220 Ξ© is perfect.
  3. Upload the blink sketch below with the LED on pin 8.


void setup() {
 pinMode(8, OUTPUT);
}

void loop() {
 digitalWrite(8, HIGH);
 delay(300);
 digitalWrite(8, LOW);
 delay(300);
}

Good to know

Connecting an LED without a resistor can burn it out in seconds and can damage the microcontroller pin.

You might also like

5mm LED Yellow Color

5mm LED Yellow Color

In Stock

RWF 100

5mm LED White Color

5mm LED White Color

In Stock

RWF 100

5mm LED Blue Color

5mm LED Blue Color

In Stock

RWF 100

5mm LED Green Color

5mm LED Green Color

In Stock

RWF 100